A control of a vehicle motion control device 10 is as follows during an oversteer restraining control. Specifically, when tire inflation pressure is appropriate, the device sets braking force exerted on each of front and rear wheels at the outer side of the turning direction so as to be reference braking forces Ff1 and Fr1, that are generated when an absolute value of a lateral acceleration deviation .DELTA.Gy is not less than a reference value a1 and that respectively increase up to an upper limit value ff and upper limit value fr in accordance with the increase in the absolute value of the lateral acceleration deviation .DELTA.Gy. On the other hand, when a tire inflation pressure of one of the front and rear wheels at the outer side of the turning direction is lowered, the device sets the braking force, such that the braking force starts to be generated from when the absolute value of the lateral acceleration deviation .DELTA.Gy is smaller than the reference value a1 by an amount in accordance with the reduction in the tire inflation pressure and that the upper limit value of the braking force with respect to the wheel whose tire inflation pressure is lowered is decreased by an amount in accordance with the reduction in the tire inflation pressure and that the upper limit value of the braking force with respect to the wheel that is not the wheel whose tire inflation pressure is lowered is increased by an amount in accordance with the reduction in the tire inflation pressure.