Securement of head rest support into automobile seat frame

   
   

The headrest support tubes are secured to the seat frame member not by the usual welding, but by gripping the web of the member between two rings or lock-beads swaged into the metal of the tube. The first ring is swaged-out by compressing the tube. The tube, with the one ring, is then assembled into a through-hole in the web of the frame member. Then, the second ring is swaged into the metal of the tube, on the other side of the web, and the web lies gripped between the rings. The seat frame member may be an I-section extrusion, or a round tube with localised squeezed-flat areas, flanked by flanges.

Les tubes de soutien d'appui-tête sont fixés au membre de structure du siège pas par la soudure habituelle, mais en saisissant l'enchaînement du membre entre deux anneaux ou serrure-perles étampés dans le métal du tube. Le premier anneau est étampé-dehors en comprimant le tube. Le tube, avec l'un anneau, est alors assemblé dans un à travers-trou dans l'enchaînement du membre d'armature. Puis, le deuxième anneau est étampé dans le métal du tube, de l'autre côté de l'enchaînement, et les mensonges d'enchaînement saisis entre les anneaux. Le membre de structure du siège peut être une extrusion de Je-section, ou un tube rond avec des secteurs serrer-plats localisés, flanqués des brides.

 
Web www.patentalert.com

< Process for manufacturing a high strength container, particularly an aerosol container, and the container obtained through such process

< Flexible compositions based on propylene polymers

> Method for molding ceramic sheet

> Plastic label holder with integral sign holder

~ 00147